Antimagnetic Rotor Bearing

High-load Thrust Bearing

AFLAS or FFKM Sealing Ring

Labyrinth Protector

 Applicable to Vertical Well

High-load Thrust Bearing

Hard-hard Mechanical Seal (Abrasive Resistant)

MONEL K-500 High-strength Shaft

Bag Protector

 Applicable to Deviated/Vertical Well

High-load Thrust Bearing

Hard-hard Mechanical Seal (Abrasive Resistant)

MONEL K-500 High-strength Shaft

Inside of the motor is effectively isolated from the well fluid.

Combined protector

 Applicable to Deviated/Vertical Well

High-load Thrust Bearing

Hard-hard Mechanical Seal (Abrasive Resistant)

MONEL K-500 High-strength Shaft

Different combinations of labyrinth and bag protector chambers are available through modular units.

338/387/400/513/675 Series of Rotary Gas Separator

Tungsten carbide bearings offer better abrasive resistance and lengthen the service life.

Investment Casted Ni-resist Impeller

AR, AC Design for a Variety of Well Conditions

MONEL K-500 High-Strength Shaft

387/400/513 series separators are compatible with REDA products through the same connection dimensions.

675 series separator is independently developed.

Precisely Calibrated Dynamic Balancing

Rotary gas separators are classified into single tandem and center tandem in terms of configuration. Tandem deployment can further improve the gas separation performance.

387/400/513 Series of Vortex Gas Separator

Tungsten carbide bearings offer better abrasive resistance and lengthen the service life.

Investment Casted Ni-resist Impeller

AR, AC Design for a Variety of Well Conditions

MONEL K-500 High-Strength Shaft

Precisely Calibrated Dynamic Balancing 

338/387/400/513/538/675 Series Submersible Pump

Computer Aided 3D Design, Efficient and Energy-saving

Wide Range of Capacity

FL, BFL, compression configuration and AR, AC design develop wide adaptation for different well conditions.

Investment casted ni-resist stages offer better stability and performance.

MONEL K-500 High-Strength Shaft

Anti-wear Material Thrust Washers

Tungsten Carbide Bearings

338/387/400/513/538 design have the same connection dimensions of the REDA products.

675 series pumps are independently developed.

Note: We can also supply the following products.

387/513/675 Series of Vertical Water Injection Pump

All Series of Anti-corrosive Submerged Pumps

Separator / Intake

 Machined Parts

We uses advanced CNC machining tool to process parts and components used by electric submersible pump to ensure the high dimensional and positional accuracy of the parts.

We adopt modern information management means to make sure each product is effectively controlled during each working process and the traceability of parts and components have been improved.

Cutting-edge testing equipment has been used, such as CMM (coordinate measuring machine), to make sure the processing quality meets the requirements of drawing.

All the operators have been offered professional training and have higher professional skill.

WE would like to provide our customers with the machined parts for various electric submersible pumps and can also process parts and components for various electric submersible pumps as per user’s need.

mpellers and Diffusers